Rice Lake IQ plus 390-DC Live Weighing Option Configuration and Operation Instructions - Manual (Page 2)

2 IQ plus 390-DC Live Weighing Option
Serial Data Considerations
W h e n o p e r a t i n g i n l ive w e i g h i n g m o d e w i t h
AUTOPRT set OFF, ensure that the acquired weight
display time (DSPTIM parameter) is set to a large
enough value to allow the operator time to press the
PRINT key to generate a demand print ticket, if
required. In live weighing mode, the PRINT key can
send data to the serial port only while the acquired
weight is displayed; pressing the
PRINT key at any
other time acquires a new weight sample.
Demand print data (SERIAL menu STREAM
parameter set OFF) uses the NFMT ticket format if a
tare is in the system, GFMT if no tare is acquired or
entered. The <G> format command on the GFMT
ticket and the <N> format command on the NFMT
ticket both represent the animal weight.
When streaming continuous data (SERIAL menu
STREAM parameter set to LFT or INDUST), the
weight data displayed or printed depends on the value
set for the WEIMOD parameter: If WEIMOD is set to
BLANK and no weight data is shown on the current
display, streamed weight data is also blank.
Live Weighing Program Menu
Figure 1. ANIMAL Submenu on IQ plus 390-DC PROGRM Menu
XXXXXXX XXXXXXX VERS PROGRM PFORMT SERIAL CALIBR CONFIG FORMAT
ANIMAL
ACCESS
ENABLE
DSABLE
000040
000001–
002400
SMPTIM
000080
000001–
999999
DSPTIM
OFF
ON
WEIMOD
NORMAL
BLANK
AUTPRT GO
DELAY
PWRUPM • • •
(same as standard
PROGRM menu)
sample and display times
specified in 0.1-second intervals
PROGRM Menu / ANIMAL Submenu
Parameter Choices Description
Level 3 Submenus
ACCESS ENABLE
DSABLE
Animal mode access. Specify ENABLE to use the live weighing option; specify DSABLE to
operate as standard indicator.
SMPTIM 000040
number
Sample time. Specifies, in 0.1-second intervals, the sample time during which animal
weight is acquired. The default value (000040) is 4 seconds.
DSPTIM 000080
number
Display time. Specifies, in 0.1-second intervals, how long the acquired animal weight is
displayed. The default value (000080) is 8 seconds.
AUTPRT OFF
ON
Automatic print. Specifies whether animal weight data is automatically sent to the serial
port once the weight is acquired.
WEIMOD NORMAL
BLANK
Weigh mode. Specifies whether the indicator display shows the current scale weight
(NORMAL) or is blank (no weight data) when the acquired weight display time expires.
Table 1. ANIMAL Submenu Parameters on PROGRM Menu