Rice Lake JB4SS TuffSeal Signal Trim Junction Box - Manual (Page 4)

2. TuffSeal Junction Box Mounting Procedure
The TuffSeal junction boxes include two different sizes:
• 4-Channel small enclosure (JB4ES and JB4SS)
• 4-Channel mid-range FRP enclosure (JB4EP and JB4SP)
The following sections describe the correct mounting procedure used for each.
2.1 Mounting the Small Junction Box (JB4ES and JB4SS)
The junction box should be mounted in a location that is convenienent for servicing
and away from standing water. Try to mount the enclosure in a location so that the
load cell cables need not be cut, nor length added. Load cell output is temperature
com pen sat ed for the supplied cable length. Altering that length can change the
cell's signal output.
Depending on the mounting surface, the JB4ES or JB4SS enclosure can be attached
using two pan-head screws, bolts, or other suitable fasteners. Figure 2, below, shows
the di men sions for mounting the en clo sure.
Figure 2: JB4ES and JB4SS Enclosure Dimensions
2

NN

NN

NN

NN
$PSE
(SJQ )PNF
3VO
$BCMF
#SFBUIFS
7FOU


4-

1(
$PSE
(SJQT

$BCMF
%JBNFUFS
w

w


4-

1(
$PSE
(SJQT

$BCMF
%JBNUFS
w

w
)PMF
%JB