Parts assembly, 1 assembling the base plate – Rice Lake Magnamount User Manual
Page 4
2
2. Parts Assembly
The MagnaMount can be assembled as one unit and hoisted into place on the
foundation, or it can be assembled part by part onto the foundation. This section
describes the assembly of the mount into one unit.
2.1 Assembling the Base Plate
1.
Screw the four leveling bolts into the base plate.
2.
Place the two corner stands on the base plate (see graphic below).
3.
Place the flexure plate over the two corner stands.
4.
Place the two anchor blocks on top of the flexure plate in line with each
corner stand.
5.
Screw anchor bolt through the anchor blocks, flexure plate, and corner
stands to the base plate using the eight anchor block bolts and washers
(only six anchor block bolts and washers for the 100,000 lb capacity mount
and only four for the 50,000 lb).
6.
Torque the anchor block bolts to spec (see torque value table, page 4).
Base Plate Assembly
50K—5/8"—11 x 3"
100K—5/8"—11 x 3"
200K—7/8"—9 x 5-1/4"
Anchor Bolt
Anchor Block
Flexure Plate
Stand
Leveling Bolt
Base Plate
50K—5/8"—11 x 6"
100K—3/4"—10 x 9"
200K—1"—8 x 12"
Flat Washer
50K—5/8"
100K—3/4"
200K—1"