Rice Lake MSI9300 PortaWeigh Crane Scale Setup Exit Guide - Manual (Page 4)

Page 3 of 5
6). Wait for a minimum of 1 min. PC screen may or may not refresh automatically,
dependent upon terminal program used. Type @W1 . Applied load should appear as
shown.
7). Procedure is now complete. Disconnect comm. cable from scale and cycle power.
Please note that any previously set TARE, ZERO, and TOTAL values will NOT be saved or
recovered. These values, if used, will need to be re-entered via normal scale operations.
***** Commport 1 Settings *****
(1) Function: Host
(2) Baud rate: 9600
(3) Standard: RS-232
(4) Mode: Duplex
(5) Data bits: 8
(6) Parity: None
(7) Type: MSI
(8) Protocol/Handshake: None
(b) Control: On command
(d) Interval: every 1000 milliseconds
(e) Motion: Enabled
(N) APPLY ALL COMMPORT SETTINGS NOW!
(ESC) Exit
0 LB GROSS