Rice Lake Scout Pro Series Portable, Ohaus - Quick Start Guide - Manual

Quick Start Guide Scout

Pro Balance
Ohaus Corporation www.ohaus.com i Scout  Pro Balance Quick Start Guide
PREPARATION FOR USE
Release Shipping Lock on top of the balance
Turn the pointer 90° counter-clockwise.
Install the Platform
Rectangular platform: Place diagonally on sub-
platform and rotate counter-clockwise until it locks.
Round platform: Set straight down on subplatform.
Draft Shield models: Position draft shield
on top and rotate it until it faces forward.
Connect Power
Ensure voltage identification label matches
local line voltage. If not, do not connect the unit.
Contact Ohaus or your dealer.
Battery Installation
Install the Four “AA” batteries with polarity
as shown in the battery compartment.
Balances with leveling
feet and bubble must
be leveled before
using. (Bubble is at
rear, next to AC
Adapter Input Jack.)
SELECTING THE LOCATION: Place on a firm, steady surface with sufficient space.
Avoid excessive air current, vibrations, heat sources, or rapid temperature changes.
SAFETY PRECAUTIONS
• Before plugging in the balance, verify that local power supply matches voltage printed
on power adapter. (Use only the adapter provided with the balance.)
• Disconnect the balance from the power supply when cleaning.
• Do not operate this product in hazardous or unstable environments.
• Do not drop loads on the pan.
• Use only approved accessories and peripherals, as available.
• Operate the product only under ambient conditions specified in the Instruction Manual.
• Service should be performed by authorized personnel only.
Pointer
Locked
position
Unlocked
position
Subplatform
Adapter jack