Rice Lake Star SP700 - Manual (Page 121)

– 118 –
APPENDIX
• To adjust, use the FEED switch to select the adjustment pattern from the
printout with the smallest gap between the first printing pass and the return
printing pass. Press the FEED switch once to specify the first adjustment
pattern, twice to specify the second adjustment pattern, and so on up to seven
times to specify the seventh adjustment pattern.
Press and hold the FEED switch the last time you press the switch.
(For example, if you want to select the fourth adjustment pattern, press the
FEED switch three times. Then, press and hold the FEED switch until the long
buzzer sounds.)
There are only seven adjustment patterns. The buzzer will sound each time the
FEED switch is pressed. However, if you press the FEED switch more than
seven times, a warning alert will sound.
After selecting the adjustment pattern, the setting value is stored in the non-
volatile memory. A printout similar to the one below with the selected
adjustment pattern highlighted and the message “Adjust Completed!” will be
printed.
Note: Before the printout is printed, the setting value is stored in the non-
volatile memory of the printer after the adjustment pattern has been
selected and the long buzzer sounds. During this period, do not set the
power switch to off. If this power switch is set to off when the setting
value is being stored in the non-volatile memory, the setting value for
the adjustment pattern and all of the memory switch settings will be
reset.
Fig. 6-3 Dot Alignment Adjustment Sample 2
• The long buzzer sounds once more and the setting value is automatically set.
The adjusting the dot alignment mode is complete.