Rice Lake SURVIVOR 420HE Hostile Environment - Operator Card - Manual (Page 3)

3
1.9 Display or Change Setpoint Value
To display a setpoint value, enter front panel setup
mode. Press
DOWN or ENTER to display SETPT1 . The
LEFT/RIGHT keys toggle through both setpoints if
operator accessible. Press DOWN or ENTER to display
ENABLE . Use the LEFT / RIGHT keys to toggle to VALUE .
Press DOWN or ENTER to view the value. See Figure 2.
NOTE : Setpoint Value, Band Value and Hysteresis can
be accessible from the front panel in the weigh mode.
To change the setpoint value, use the UP/DOWN keys
to increment/decrement the decimal value of the
flashing digit. Press
ENTER to move to the decimal
point entry. LEFT/RIGHT keys adjust the decimal point
placement. Press the EN TE R key to accept the
displayed value and return to the next value or
setpoint number prompt. Press the
UP key to exit. See
Figure 2.
1.10 Turn Setpoint On or Off
To turn a setpoint on or off at the front panel, enter
front panel setup mode. Press
DOWN or ENTER and
SETPNT is displayed. Press DOWN or ENTER again to
display SETPT1 .The LEFT/RIGHT keys toggle through
each setpoint that is operator accessible. Press DOWN
or ENTER and ENABLE is displayed. Press RIGHT or
LEFT to turn the setpoint ON or OFF . Press the UP key
to exit.
1.11 Print Ticket
1. Wait for standstill annunciator ( ).
2. Press the PRINT key to send data to the serial
port.
Figure 2. Front Panel Setpoint Setup
SETPNT
number
V ALUE
number
BNDVAL
number
HYSTER
OFF
ON
ENABLE
SETPT2
Sub Menu – Press and hold UNITS key for three seconds
SETPT1
Same as SETPT 1
T/DATE
DATE
010104
TIME
0000
NOTE: Only Available when ACCESS = ON
See Figure 3-11 on page 23 and Table 3-7
on page 24 for more information.
NOTE: The indicator will begin
incrementing time at power up.