Ring Communications DAD104b OPERATIONS MANUAL - Manual (Page 8)

DAD104 Operations Manual March 2012
feature is not used, calls can be handled on a first in first out basis by starting at the uppermost active
line. When each call is canceled each D
ISPLAY
L
INE
will automatically move up, and the top active
D
ISPLAY
can be used each time until all lines are handled.
SILENCING THE AUDIBLE ANNUNCIATOR TONE -
When an incoming annunciation is received and cannot be handled immediately, the tone can be
temporarily silenced by pressing the C
ANCEL
key. If any additional activity occurs, the audible tone will
sound again.
The audible tone will also sound if another event is received while you are presently handling one.
Two options are available to handle a event while in conversation: One is to complete the present call,
press cancel, then proceed to handle the additional events. The second option is to place the present
call in P
ARK
, then answer the additional events to assess the priority of the call handling using P
ARK
or
C
ANCEL
as needed.
NIGHT TRANSFER MODE -
The DAD104 is placed in Night Transfer mode by placing the associated intercom station in privacy.
Calls to this DAD104 will now be sent to the next DAD104 in the Annunciator chain without the
programmed delay. The delay is used in normal Day mode to delay calls before they transfer (Max
delay 9.9 minutes). When the DAD104 is in transfer mode the time display will flash the word
“TRANSFER” . Calls are still qued in the DAD104 but the beeper is silenced. The beeper will beep
once every 40 seconds as a reminder that the we are in transfer mode. The DAD104 may answer
calls in the Que while in transfer mode.
SET SYSTEM TIME/DATE -
The Time and Date menu is accessed with the following key sequence:
PARK - REMOTE CONTROL - PARK - REMOTE CONTROL
Use the SCROLL keys to move through the menu.
Use the ANSWER keys to Increment or decrement Time, Date or other options.
Change: Time, Date, Clock ON/OFF and Language select (English, German, French,Spanish,
Catalan).
The CANCEL key exits the menu. No keys pushed for 50 seconds also exits the menu.
SUPERVISION OF CONNECTION TO THE CENTRAL EXCHANGE-
When the DAD104 is powered up or reset it will send a log on message out on the RS485 Network
asking what master station it is associated with. The Central Exchange will respond with the call
number and subscriber address of that master station. The DAD104 will then start to monitor the
connection with the Central Exchange that sent the response. If the connection fails the DAD will
display the following error message:
Line 1 - nn:76543210
nn = the network number that the DAD is connected to.
The numbers are nodes present on this network.
Line 2 - Net:nn Node:m
nn = the network number of the DAD
m = the node number of the DAD
Line 3 - Address:aa
aa = the network address of the DAD (the 8 bit dip switch).
Line 4 - Not Active
Not active to answer calls.
Page8
Ring-Master