Crestron electronic Multimedia Presentation System 300 MPS-300 - Manual (Page 65)

Crestron MPS-300 Multimedia Presentation System 300
Display the IP Address
IP Address
[000] 000. 000. 000
• Turn the volume control clockwise or counterclockwise to select a number
in the left-most section of the IP address. You can also press the k or j
buttons to select a number.
• Press ENTER to move the cursor to the next section of the address. To
change a different section, press the soft button under the section to be
changed.
• Repeat the previous two steps until the entire IP address is set.
• To save the new address and return to the Network Setup menu, move the
cursor to the right-most section and press ENTER. To cancel the operation
and return to the Network Setup menu, press MENU.
Set the Subnet Mask The MPS-300 can be configured to use an IP Subnet Mask for TCP/IP
communications. To set the address of the IP Subnet Mask:
• Access the Network Setup menu as described on page 60.
• Press the k or j buttons until “Subnet Mask” is displayed on the LCD and
press ENTER to display the Subnet Mask controls. The current IP address
of the Subnet Mask will be displayed.
Display the IP Subnet Mask Address
Subnet Mask
[000] 000. 000. 000
• Turn the volume control clockwise or counterclockwise to select a number.
You can also press the k or j buttons to select a number.
• Press ENTER to move the cursor to the next section of the address. To
change a different section, press the soft button under the section to be
changed.
• Repeat the previous two steps until the entire Subnet Mask IP address is set.
• To save the new address and return to the Network Setup menu, move the
cursor to the right-most section and press ENTER. To cancel the operation
and return to the Network Setup menu, press MENU.
Operations Guide – DOC. 6529B Multimedia Presentation System 300: MPS-300
• 61