SINGER 9340 SIGNATURE - Manual (Page 64)

5
This foot is used to trim excess material while sewing.
1. Attach the
, making sure the cutter's "arm" fits around the needle clamp. Tighten the
thumb screw, securing the foot.
2. Slowly turn the handwheel towards you; the needle should go over the stitch finger on the foot.
If the needle is hitting the metal stitch finger or metal side, then widen or narrow the stitch width.
Never use a straight stitch.
3. Cut a 1/2" wide by 1"deep notch at the top edge of your fabric.
4. Place the fabric OVE
orks best if no more than 1/2" is
being trimmed.
R the first metal platform and then UNDER the second metal platform. If the
foot is not cutting, it is usually because the material is not placed OVER the first metal platform.
5. Sew slowly and gently guide the fabric. The foot w
Cut & Hem
Cut & Hem
* The is an optional accessory. Cut & Hem
59
B-10
5.0~7.0 2.0~4.5
7
CUT & HEM
This foot includes a built-in roller to help feed difficult-to-sew fabrics such as leather, suede and
vinyl.
1. Manually lead the thread from the needle through the opening of the foot, and then slip the
thread under and behind the foot.
2. Use double-faced (basting) tape to hold the fabric pieces together for sewing, which will prevent
either layer from slipping.
3. Place fabric under the presser foot. Lower the presser foot and sew.
* The roller foot is an optional accessory.
ROLLER FOOT
1
3.0~4.5
* The s is an optional accessory. traight stitch foot
STRAIGHT STITCH FOOT
This foot is used when sewing lightweight fabrics, such as chiffon and silk. It will help prevent the
fabric from being pulled into the needle plate opening.
1. Set the machine for straight stitch, center needle position. Verify that the needle will line up with
the opening of the foot before starting to sew.
2. Sew slowly and guide the layers.
1
2.5