Caution, Features, Attention – Smart Power Systems POS Guardian User Manual

Page 2

Advertising
background image

1.Turn off and un-plug equipment to be protected from wall outlet.
2. Plug the equipment into the POS Guardian

.

3. Plug the POS Guardian unit into grounded wall outlet.
4. Your equipment is now fully protected. Place the POS Guardian where monitoring lights
can be observed.

unit

Installation of TBF™

Use this user's guide for the following products:

Modem & Data Protection (model dependent)
Protection is extended to your phone and network lines with the addition of RJ11 and RJ45 jacks
on the POS Guardian unit, creating ideal protection for Fax/Internet/Network users. Power
surges can pass to the connected equipment through phones lines and network cables.

CAUTION

CAUTION

CAUTION

CAUTION

• Use only in dry locations indoors.
• Avoid dropping the unit.
• Only plug the POS Guardian into a three pronged grounded outlet. This unit is not to be used
with any type of ground “lift” or pin eliminator.
• Do not open the POS Guardian unit, there are no serviceable parts inside. Opening the unit
will void your warranty.

This device features an internal protection that will disconnect the surge protective component
at the end of its useful life but will maintain power to the load now unprotected. If this situation
is undesirable for the application, follow the manufacturer's instructions for replacing the device.

Do not install this device if there is not at least 10 meters (30 feet) or more of wire between the
electrical outlet and the electrical service panel.

Risk of Electric Shock. Do not plug into another relocatable power tap.

FEATURES

If you have any questions call us at our Tech Support line toll free
1-800-772-7633 or email us at [email protected]

DESCRIPTION

MODEL / PART NUMBER

120V/15A, two 5-15R outlets

TBF15P-1120

120V/15A, two 5-15R outlets, RJ11 + RJ45
120V/15A, one pigtail 5-15R outlet, RJ11 + RJ45

TBF15P-1121TN
TBF15P-1111TN

•• Utiliser uniquement dans des endroits secs à l'intérieur.
• Évitez de faire tomber l'appareil.
• Brancher le POS Guardian en trois volets prise de terre. Cette unité ne doit pas être utilisé avec
tout type de terrain "ascenseur" ou broches éliminateur.
• Ne pas ouvrir l'unité POS Guardian, il n'y a pas de pièces réparables. Ouverture de l'unité
annulera votre garantie.

Cet appareil dispose d'une protection interne qui va déconnecter le composant de protection contre
les surtensions à la fin de sa vie utile mais se maintenir au pouvoir à la charge maintenant sans
protection. Si cette situation est souhaitable pour l'application, suivez les instructions du fabricant
pour le remplacement de l'appareil.

Ne pas installer cet appareil si il n'y a pas au moins 10 mètres (30 pieds) ou plus de fil entre la prise
électrique et le panneau de service électrique.

ATTENTION

ATTENTION

ATTENTION

ATTENTION

Risque de choc électrique. Ne branchez pas dans une autre puissance robinet délocalisables.

Advertising