Smart Power Systems Smart30 - Manual (Page 3)

1.Turn off and un-plug equipment to be protected from wall outlet.
2. Plug the equipment into the Smart30
.
3. Plug the Smart30 unit into grounded wall outlet.
4. Your equipment is now fully protected. Place the Smart30 where monitoring lights can
be observed.
Unit
INSTALLATION OF SMART30
WALL MOUNT INSTALLATION
Connected
Equipment
Power Cord
Power Cord
ATTENTION
CAUTION
In case of reverse phase sequence in 3 phase models (RED LED ON), the phase sequence should
be corrected at the wall outlet by a certified electrician. Reverse phase sequence might lead to
malfunction of the 3 phase equipment.
If you have any questions call us at our Tech Support line toll free
1-800-772-7633 or email us at [email protected]
OUTPUT RECEPTACLE
OUTPUT
RECEPTACLE
INPUT PLUG
WITH CORD
INPUT PLUG WITH CORD
PHASE SEQUENCE INDICATORS
NORMAL REVERSE LINE 1 LINE 2 LINE 3
LINE 3 LINE 1
NORMAL
REVERSE
LINE 2
PHASE
SEQUENCE
INDICATORS
POWER LINE INDICATORS
Smart30
ON FAULT
FRONT VIEW
REAR VIEW
FRONT VIEW
REAR VIEW
3-PHASE
3-PHASE
SINGLE PHASE
SINGLE PHASE
BACK OF UNIT
To mount your Smart30 unit to a wall or
other surface, first, install four screws (not
included) on the wall, where monitoring
lights can be observed. Leave 1/4 inch of
the screw exposed. Use the two mounting
holes in the back of the Smart30 by sliding
them into the exposed part of the screws
and lock into place.
En cas de séquence de phase inverse en 3 modèles de phase (LED rouge sur), la séquence de
phase devrait être corrigé à la prise murale par un électricien certifié. Séquence de phase inverse
peut entraîner un dysfonctionnement de l'équipement en 3 phases.