Snow Joe SPX3001 Pressure Joe 2030 PSI 1.76 GPM 14.5-Amp Electric Pressure Washer with Hose Reel - Manual (Page 7)

5. To assemble the spray wand protector, first snap the tabs
into the slots located at the bottom left side of the unit,
and then secure it in place with the other screw (Fig. 5).
6. Fit the spray wand into the trigger gun and rotate it until
the two parts are completely locked (Fig. 6).
7. Connect the high-pressure hose to the trigger gun
(Fig. 7).
m
WARNING! Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hoses regularly and
replace if damaged. Do not attempt to mend a damaged hose.
8. Connect the garden hose adaptor (female coupler) to
the water inlet of the pressure washer, then thread your
garden hose (male end) into the garden hose adaptor
(Fig. 8). The garden hose must have an internal diameter
of at least 13 mm (1/2 in.) and must be reinforced. The
water supply must be at least equal to the washer delivery
capacity.
NOTE: The machine is not suitable for connection to a
potable water main.
Fig. 4
Suction tube with filter
Fig. 5
Screw
Spray wand protector
Fig. 6
Trigger gun
Spray wand
High-pressure hose
Trigger gun
Fig. 7
Fig. 8
Water inlet
(female coupler)
(FRONT)
Garden hose
This end to the
water inlet on
the unit
Garden hose
(male end)
7