Snow Joe AJ800E-RM Dethatcher Joe 14-Inch 11-Amp Electric Dethatcher with Thatch Collection Bag - Manual

© 2013 by Snow Joe, LLC
All rights reserved. Original instructions.
SAVE THESE INSTRUCTIONS
14-IN 11 AMP Electric Dethatcher 14-IN 11 AMP Electric Dethatcher
A Division of Snow Joe ® , LLC
Model No. AJ800ERM
Form No. SJ-AJ800ERM-880E
OPERATOR’S MANUAL
IMPORTANT!
Safety Instructions
All Operators Must Read These
Instructions Before Use
Always follow these safety guidelines. Failure to do so may
result in serious bodily injury or death.
Safety Precautions
TO REDUCE RISK OF INJURY: Before any use be sure
everyone using this product reads and understands all safety
instructions and other information contained in this manual.
m
WARNING!
When using electric gardening
appliances, basic safety precautions should always be
followed to reduce risk of fire, electric shock, and/or
personal injury.
Save these instructions and review frequently prior to use
and in instructing others.
Safety Instructions
1. Thoroughly inspect the area where the equipment is to be
used and remove all foreign objects.
2. Do not operate the equipment without wearing adequate
outer garments. Wear protective footwear that will improve
footing on slippery surfaces.
3. Use extension cords and receptacles as specified by the
manufacturer for all units with electric drive motors or
electric starting motors. (SEE TABLE 1)
4. Never attempt to make any adjustments while the motor is
running.
5. Do not put hands or feet near or under rotating parts.
6. Exercise extreme caution when operating on or cross-
ing gravel drives, walks, or roads. Stay alert for hidden
hazards or traffic.
7. After striking a foreign object, stop the motor, thoroughly
inspect the machine for any damage, and repair the
damage before restarting and operating the machine.
Disconnect the cord on electric motors.
8. Exercise caution to avoid slipping or falling.
9. If the unit should start to vibrate abnormally, stop the
motor and check immediately for the cause. Vibration is
generally a warning sign of trouble.
10. Stop the motor when leaving the operating position,
before unclogging the tines, and when making any repairs,
adjustments, and inspections.
11. Take all possible precautions when leaving the machine
unattended. Stop motor and remove the power cord.
12. Before cleaning, repairing, or inspecting, shut off the
motor and make certain all moving parts have stopped.
Disconnect the cord on electric motors.
13. Never operate the machine without proper guards, plates,
or other safety protective devices in place.
14. Keep children and pets away.
15. Do not overload the machine capacity by attempting to
cultivate too deep at too fast a rate.
16. Never operate the machine at high transport speeds on
hard or slippery surfaces.
17. Never allow bystanders near the unit when operating.
18. Use only attachments and accessories approved by the
manufacturer of the machine.
19. Never operate the machine without good visibility or light.
20. Be careful when cultivating in hard ground. The tines may
catch in the ground and propel the machine forward. If this
occurs, let go of the handlebars and the starting lever and
do not restrain the machine.
22. Use extreme caution when reversing or pulling the
machine towards you.
22. Switch on the motor carefully according to instructions
and with feet well away from the tines.
23. Never pick up or carry a machine while the motor is
running.
24. Do not operate the machine while under the influence of
alcohol or drugs.
General Safety
• AVOID DANGEROUS ENVIRONMENTS – Don’t use this
product in rainy, stormy, damp or wet locations. Do not
operate in gaseous or explosive atmospheres. Motors in
these products normally spark, and the sparks might
ignite fumes.
• DRESS PROPERLY – Don’t wear loose clothing or jewelry
and wear protective hair covering to contain long hair.
They can be caught in moving parts. Use of rubber
gloves and substantial footwear is recommended
when working outdoors.
• USE SAFETY GLASSES – Wear safety glasses with side
shields or goggles that are marked to comply with ANSI
Z87.1 standard when operating this product.
1