Snow Joe iON18SB-RM Cordless Single Stage Snow Blower With Rechargeable Ecosharp 40 Volt Lithium-Ion Battery - Manual (Page 12)

12
Replacing the Scraper Bar
1. The scraper bar is located at the base of the snow blower
beneath the rotor housing (Fig. 21).
2. Detach the worn scraper bar from the snow blower by
removing the 4 screws that hold it in place (Fig. 22).
3. Install the new scraper bar and fasten it securely to the
snow blower with 4 screws (Fig. 21).
Storage
1. Clean the snow blower before storing or transporting.
Be sure to secure the unit while transporting.
2. Remove the battery and the safety key from the snow
blower.
3. Inspect the snow blower carefully for worn, loose, or
damaged parts. Check connections and screws and
tighten if necessary. For repairing or replacing parts,
contact your Snow Joe ® dealer or Snow Joe ® customer
service center at 1-866-766-9563.
4. Store the unit in a locked, dry place out of the reach of
children to prevent unauthorized use or damage. Cover
loosely with a tarp for added protection.
Battery/Charger Off-Season Storage
1. Do not expose your battery pack or charger to water,
rain, or allow them to get wet. This could permanently
damage the charger and the battery pack. Do not use oil
or solvents to clean or lubricate your battery pack as the
plastic casing can become brittle and crack, causing a
serious risk of injury.
2. Store the battery pack and charger at room temperature
away from moisture. Do not store in damp locations where
corrosion of terminals may occur. As with other battery
pack types, permanent capacity loss can result if the pack
is stored for long periods of time at high temperatures
(over 120ºF (49ºC)). Snow Joe ® iBAT40 lithium-ion battery
packs maintain their charge during storage longer than
other battery pack types. After about a year of storage,
charge the pack as you normally would.
3. As a general practice, it is best to unplug battery chargers
and remove battery packs when they are not in use.
However, battery pack damage will not occur if the
charger and battery pack are left plugged in.
Environmentally Safe Battery
Disposal
Always dispose of your battery pack according to federal,
state, and local regulations. Contact a recycling agency in your
area for recycling locations.
m
CAUTION!
Even discharged battery packs contain
some energy. Before disposing, use electrical tape to cover
the terminals to prevent the battery pack from shorting, which
could cause a fire or explosion.
m
WARNING!
To reduce the risk of injury or explosion,
never burn or incinerate a battery pack even if it is damaged,
dead, or completely discharged. When burned, toxic fumes
and materials are emitted into the surrounding atmosphere.
Service and Support
If your Snow Joe ® iON18SB snow blower requires service or
maintenance, please call 1-866-766-9563 for assistance.
Model and Serial Numbers
When contacting the company, reordering parts, or arranging
service from an authorized dealer, you will need to provide the
model and serial numbers, which can be found on the decal on
the main cover of the unit of the discharge chute. Copy these
numbers into the space provided below.
Fig. 21 Scraper bar 4 Screws
Fig. 22
Record the following numbers from the housing or handle of your
new product: Model #:
Serial #:
i O N 1 8 S B R M