Symtech HBA 5 With Line Laser - Manual (Page 3)

3
INDEX
1. GENERAL Pg. 5
1.1 GENERAL ASSEMBLY INSTRUCTIONS
1.2
BASE / MAST CALIBRATION
1.3 LINE LASER CALIBRATION PROCEDURE
2. SYSTEM COMPONENTS Pg. 65
2.1 CONTROL PANEL
2.1.1 ADJUSTMENT SELECTION BUTTON
2.1.2 ON/SELECT BUTTON
2.1.2.1 POSITION CHECK/BATTERY CHARGER LEVEL
2.1.2.2 HEADLAMP BEAM SELECTION
2.1.3 INTENSITY CHECK + BATTERY CHARGER METER
2.1.3.1 READING INTENSITY AND BATTERY CHARGER METERVEHICLE ALIGNMENT LINE LASER
2.1.4 LAMP POSITION INDICATOR ARROWS
2.1.5 BATTERY CHARGER SOCKET
2.1.5.1 BATTERY PACK
2.2 ALIGNMENT HEAD
2.2.1 OPTICAL HEAD
2.2.2 POSITION SENSORS
2.2.3 LEVEL VIALS
2.3 MAST
2.3.1 GLIDE PLATE
2.4 WHEEL BASE
2.4.1 FLOOR SLOPE ADJUSTMENT WHEEL ASSEMBLY
2.4.2 UNIT LEVELING ADJUSTMENT WHEEL ASSEMBLY
2.4.3 WHEELS TO WHEELBASE MOUNTING
2.5 FLOOR RAIL
2.5.1 FLOOR RAIL OPERATION
2.6 VEHICLE POSITIONING LINE LASER
2.7 ALIGNMENT HEAD & MAST
3. OPERATION Pg. 8
3.1 ALIGNMENT BAY(s) PREPARATION
3.2 FLOOR SLOPE MEASUREMENT
3.2.1 POSITIONG THE ALIGNMENT HEAD TO THE FLOOR SLOPE
LASER BATTERY REPLACEMENT
3.3 MULTIPLE BAY ALIGNMENTS & WHEEL POSITION RECORDING
3.4 VEHICLE ALIGNMENT / POSITION TO ALIGNMENT HEAD
3.4.1 ALIGNING THE ALIGNMENT HEAD TO VEHICLE
3.4.2 SELECTING THE POSITION CHECK
3.4.3 POSITIONG THE ALIGNMENT HEAD BEFORE VEHICLE
3.5 HEADLAMP ALIGNMENT
3.5.1 CHOOSING HEADLAMP BEAM TYPE
3.5.2 ALIGING THE HEADLAMP
3.5.2.1 USING THE INDICATOR ARROWS
3.6 MAINTAINING POWER
3.6.2 CHECKING BATTERY CHARGE STATUS
3.7 OPERATING PROCEDURE, STEP BY STEP
3.7.1 LOWBEAM, HIGH BEAM, & FOG/DRIVING PROCEDURE
3.7.2 LOW BEAM, VOL & VOR ALIGNMENT PROCEDURE
4. LASER CALIBRATION PROCEDURES PG. 12
4.1 LASER CALIBRATION PROCEDURE ASSURANCE
FREQUENTLY ASKED QUESTIONS Pg. 12
WARRANTY
Pg. 14
CUSTOMER SERVICE
888-884-8182