Cobra Electronics PR3175WX - Manual (Page 11)

Memory Location Scan
•
Your microTALK ® radio can automatically scan up to ten (10)
programmed Memory Locations.
If there are one (1) or fewer memory locations
programmed in your radio, the scan memory
locations option will not be available. To program
at least two (2) memory locations, see program
memory locations on page 11.
To Scan Memory Locations:
1. Press the Mode button until the Scan icon,
Memory icon and the memory location
number flash on the display.
2. Press the Channel Up or Channel Down button
to begin scanning memory locations.
The Scan icon and the Memory icon will
continue to be displayed when memory location
scan is On. Your radio will continue to scan
memory locations and stop if an incoming
transmission is detected. Your radio will remain
on that memory location for ten (10) seconds.
While setting memory location scan, if you do
not press any buttons for 15 seconds, your radio
will automatically return to Standby mode on
the channel/privacy code displayed before
you entered mode functions.
During Memory Location Scan (while receiving an Incoming
transmission), You Can Choose From The Following:
a. Press and hold the Talk button to communicate on that
memory location. Your radio will remain on that memory
location and return to Standby mode.
b. Press the Channel Up or Channel Down button to resume
scanning memory locations.
Customer Assistance Warranty Introduction
17 Nothing comes close to a Cobra ™
Operation
16 English
Mode Functions
While setting privacy code scan, if you do not press any buttons
for 15 seconds, your radio will automatically return to Standby
mode on the channel/privacy code that was displayed before
you entered mode functions.
During Privacy Code Scan (while receiving an incoming
transmission), You Can Choose From The Following:
a. Press and hold the Talk button to communicate on that
channel/privacy code. Your radio will remain on that
channel/privacy code and return to Standby mode.
b. Press the Channel Up or Channel Down button to resume
scanning privacy codes.
If you press the Talk button while scanning and not within ten (10)
seconds of receiving a transmission, you will transmit on the
channel/privacy code on which you last received a transmission.
This will return the radio to Standby mode.
If you do not press any button within ten (10) seconds, your radio
will automatically resume scanning privacy codes.
During Privacy Code Scan (while not receiving a transmission),
You Can Choose From The Following:
a. Press and hold the Talk button to communicate on the
channel/privacy code that was displayed before you entered
mode functions or the channel/privacy code on which, during
scanning, you last received a transmission. This will return
the radio to Standby mode.
b. Press the Mode button to proceed to set memory location
scan (see page 17 for further details).
c. Press the Lock button to return to Standby mode on the
channel/privacy code that was displayed before you entered
mode functions or the channel/privacy code on which,
during scanning, you last received a transmission.
Operation
Scanning Locations
Mode Button
Channel Button
3175-PDF VERSION.qxd 11/20/03 10:45 AM Page 16