Charnwood WOODBURNER - Manual (Page 7)

chimney to be swept through the stove.
Soot doors may either be in the actual
brickwork of the chimney or in the
register plate. Various positions of soot
doors are shown in Figs. 4 to 7.
PRE LIGHTING CHECK
Ensure that the throat plate is fitted in the
roof of the appliance. The location and
positioning of the throat plate is shown in
Fig. 2.
Before initial lighting check that the front
fence is fitted correctly and that the doors
tighten properly.
COMMISSIONING
On completion of the installation and
after allowing a suitable period of time
for the fire cement and mortar to dry out,
make a layer of ash or sand on the base
of the stove, light a small fire and check
to ensure that smoke and fumes are taken
from the appliance up the chimney and
emitted safely. Also check all joints and
seals.
On completion of the installation and
commissioning please leave the operating
instructions with the customer and advise
them on the use of the appliance.
Fig. 8. Flue Blanking Plate.
Blanking Plate
Blanking Plate
Clamping Plate
with fold horizontal
Back of the Stove
Clamping plate finishes
flush with inside face of
firebox top and bottom.
with fire cement
Seal Blanking Plate
Page 7
Country 8 &12 WB 6/97