Tjernlund PAI-2T Fresh Air In-Forcer (Discontinued) 8504039 Rev A 06/00 - Manual (Page 11)

MAINTENANCE
The IN-FORCER must be inspected every 3 to 6 months. Points of inspection are:
1. Motor: Motor must rotate freely. The fan motor is permanently sealed and requires no oiling.
2. Wheel: Wheel must be clean of any foreign substance like leaves, lint or other items. Remove all foreign material from
blower assembly before operation.
3. Intake Elbow: Intake elbow screen should be clear of any foreign substance like leaves, lint or other items. Check screen
every 3 to 6 months for foreign material. Remove all foreign material from intake system before operation.
The IN-FORCER now features easy pull down servicing for maintenance, (See Diagram O).
IN-FORCER ISOMETRIC PARTS DIAGRAM
how HOW TO OBTAIN SERVICE ASSISTANCE
1. If you have any questions about your IN-FORCER or if it requires adjustment, repair or routine maintenance, we suggest that
you contact your installer, contractor or service agency.
2. If you require technical information contact Tjernlund Products, Inc. at 1-800-255-4208 or email us at [email protected].
When contacting Tjernlund Products, Inc., please have the following information available:
1. Model number and date code of the IN-FORCER
2. Name and address of installer and service agency
3. Date of original installation and dates any service work was performed
4. Details of the problem
LIMITED PARTS WARRANTY AND CLAIM PROCEDURE
Tjernlund Products, Inc. warrants the components of the IN-FORCER for one year from date of installation. This warranty covers
defects in material and workmanship. This warranty does not cover normal maintenance, transportation or installation charges for
replacement parts or any other service calls or repairs. This warranty DOES NOT cover the complete IN-FORCER if it is operative,
except for the defective part.
Tjernlund Products, Inc. will issue credit or provide a free part to replace one that becomes defective during the one year warranty peri-
od. If the part is over 18 months old, proof of date of the installation in the form of the contractor sales / installation receipt is necessary
to prove the unit has been in service for under one year. All receipts should include the date code of the IN-FORCER to ensure that the
defective component corresponds with the complete unit. This will help preclude possible credit refusal.
10
NOTE:
For pull-down servicing feature of
IN-FORCER, remove six (6)
screws from bottom front and
sides of IN-FORCER while holding
blower assembly firmly. Carefully
slide blower assembly down until
stops hold in place.
DIAGRAM O