Tycon Power TP-PP120-INV - Manual (Page 2)

TyconPower.com
05
TyconPower.com
06
TyconPower.com TyconPower.com
03 04
Warnings and Cautions:
Item list:
Q. Why will the Power Pack not charge?
A: Confirm that if you are charging from a wall outlet you
are using the charger provided.
Confirm that if you use a solar panel that it is 12VDC
type and no more than 40W capacity.
Confirm that if you are charging from a car or boat that
the engine is running during charging.
Q. Why will the Power Pack not automatically recharge
if you accidentally disconnect and then reconnect
immediately?
A: First: Confirm that you are using the correct charger.
Second: If the current or voltage is too high, the Power
Pack will engage its automatic protection feature.
Disconnect charger and restart, it should function
normally.
Q. Why does the screen turn off when the Power Pack
is fully charged?
A: The Power Pack automatically turns the screen off to
save power. Restart the Power Pack and the screen
should turn on.
Fault diagnostics:
Q. Why will the Power Pack not turn on when DC Button is pressed?
A: The battery voltage may be too low. Charge the Power Pack
using the charger provided for about 1 minute connected
to the 12V 5A Output Port. This will provide enough power
to the batteries to allow it to turn on and then accept normal
charging to the input port.
Q. Why is there no output from the “DC Output” after turn on,
when the Power Pack has been operating normally?
A: Confirm that the load does not exceed the 12V/5A rating.
If the load rate is more than 5A, the Power Pack’s automatic
protection feature will activate. Reset your Power Pack and it
should then function normally.
1. The Power Pack is suitable for short term, temporary power.
2. Please use only our recommended charger and/or solar panel.
3. We do not suggest connecting the Power Pack to high current
loads for extended periods.
4. We recommend that total output does not exceed100W.
5. Keep your Power Pack away from fire, heat, flammable and/or
combustible products.
6. Avoid any improper connections that may cause short circuits.
7. Do not leave Power Packs in areas where temperatures exceed
60 C, this may cause battery life to deteriorate faster than normal.
8. Do not use your Power Pack with wet hands or in wet conditions.
9. Always turn off the Power Pack when not in use.
output output USB
Output Port
Input Port
Wall Charger
12VDC Car Charge 4~7 hr
4~6 hr
5~15hr
AC Wall Charge
Solar panel up to 12V 40W
Charge From Times
When you need to charge, turn on
the Power Pack using DC button. Usage:
Phone Laptop
USB 5V
12VDC
AC output
Part No. Part Name Quantity
1 Tycon Power Pack 1 pc
2 DC Barrel to Wire Term Adapter 2 pcs
3 Wall Adapter 1 pc
4 User Guide 1 pc
How to fully charge your Power Pack:
How to use your Power Pack to power DC,
USB, or AC devices: