Tycon Power RPST2424-100-280 - Manual (Page 5)

5
STEP 10: Install the batteries in the
enclosure. If using multiple batteries, con-
nect in parallel for 12V output or connect
in series for 24V output.
A 12V four battery configuration is shown
to the right. If using two batteries it would
be 1/2 what you see here :
A 24V two battery configuration is shown
below:
A 24V four battery configuration is shown
to the right:
If batteries are installed on their side
make sure to apply an in-
sulator to the top of the
battery terminal to prevent
the battery terminals from
shorting to the metal en-
closure in case the battery
shifts inside the enclosure
during an earthquake.
STEP 11: Disconnect the green connector from the front of the
controller. Connect the solar and battery wires to the green connector.
Connect the Battery cables to the Battery. Be sure to observe polarity.
Black wire connects to battery negative terminal and BAT(-) terminal on
the controller. Connect the green connector to the controller. When a
fully charged battery is connected, the Green LOA LED should light on
controller.
24V
12V
24V