Universal Remote Control (URS) RFS200 - Manual (Page 13)

23 24
Favorite Channel Setup
CUSTOMIZING
CUSTOMIZING
Favorite Channel Setup Favorite Channel Setup
This is one of RF20’s most desirable features. Once it’s set up, you can select up to 40
favorite channels with the press of a button - without the need to remember or type in a
channel number. Let the channel surfing begin!
To access Favorite Channel listings, simply press the FAV button to display Page 1 of
Favorite Channel listings. There are eight pages of Favorite Channels, with five Channels
on each page, for a total of 40 Channels. Just use the PAGE ( )( ) buttons to locate the
Channel you want to setup. Each Channel can be setup to be instantly selected with the
press of one button.
IMPORTANT:
You now have 30 seconds to perform the
next step while you are in SETUP mode. If
you don’t press a button within 30 seconds,
SETUP will disappear from the screen, sig-
naling that you have exited setup mode and
you will need to start over.
FAV
BUTTON
STEP 3:
Use the PAGE ( ) ( ) buttons until you
locate the name (i.e.,ABC, CBS, NBC) of
the favorite channel you want to setup.
STEP 4:
Press the favorite channel display button
you want to setup.
The top of the screen will change to show
the channel name. The bottom of the screen
displays “STEP0”, indicating that you have
not entered the channel number yet.
STEP 5:
Press either the TV, SAT or CABLE
Component button (select the
Component you use to enter channel
numbers).
STEP 6:
Press each of the number buttons for
the channel.
Note: If a number is repeated when set-
ting the channel (for example, channel “33” or
“522”), it is usually best to set a half second delay
in between the identi-cal numbers by pressing
the (II) PAUSE button. Each press of the PAUSE
button increases the delay by a half second.
PAUSE
BUTTON
STEP 1:
Press and hold the MAIN and ENT (Enter)
buttons at the same time for approximately
3 seconds, until the word “SETUP” is
displayed at the top of the LCD screen.
This signals that you are now in setup
mode.
STEP 2:
Press the FAV display button.
The top of the display will show “FAV”.
The bottom of the display will flash
“SELECT”
NOTE: Some brands of television require an
ENT (Enter) command after the channel num-
bers.
To setup a Favorite Channel button, follow these steps: