Concord Camera Eye-Q - Manual (Page 5)

4
LOADING THE BATTERIES
The camera uses two AAA batteries as power supply.
1. Slide open the battery cover.
2. Insert 2x AAA batteries according to the polarity directions ( + ) ( – ) indicated on the inner side of the
battery door.
3. Shut the battery door.
Extending the Power Supply
To extend battery life, remove the batteries from the camera when it is not in use. Remember to transfer your
pictures to your computer BEFORE removing batteries, otherwise you will lose them.
Note:
• Always transfer your pictures to your computer before replacing the batteries.
• You may lose images stored in the camera if the battery power is insufficient.
• Do not use different types of batteries together.
• Soiling, such as fingerprints on the battery terminals, can significantly reduce battery life.
• Do not use new and used batteries together.
• Different brands of batteries will yield different results.
• The battery life of alkaline batteries may be shortened when exposed to temperatures of 10ºC or
below.
Low Battery Indication
When the batteries are nearly exhausted, the battery icon ( ) will blink, and a Beep sound can be heard.
The camera will be turned off automatically soon after. At this stage, the batteries would be too weak to take
a picture. Please connect the camera to your computer immediately so that you can transfer your pictures
to your computer and replace the batteries. Do not replace batteries if the camera is not connected to the
computer, otherwise the stored pictures would be lost!
TURNING THE CAMERA ON/OFF
1. Press and hold the Mode button for about 3 seconds to turn the camera on. The
LCD shows as below:
• When the camera is powered on, a beep sound can be heard.
2. The camera will be automatically powered off after 30 seconds of inactivity.
To turn the camera off manually,
• If there is no any icon blinking on the LCD, press and hold the Mode button for about 3 seconds to turn
the camera off.
• If there is icon blinking on the LCD, press the Mode button repeatedly until none of the icons are
blinking, then press and hold the Mode to turn the camera off.
Note: When the camera is powered off, no indicator displays on the LCD.
GETTING STARTED