Voltage Valet SP2 - Manual

Operating Instructions (Continued)
Modem/Fax Line Connection
1. Be sure your 220-240 volt device is turned off.
2. Connect the foreign phone line into the RJ11 jack labeled “Phone
Line”. (See figure 1) Note: An International Phone Adaptor may be
needed. Connect the modem/fax line into the RJ11 jack labeled
“To Modem”. Two phone cords with RJ11 connectors (not included)
may be needed to connect the foreign phone line and the
modem/fax line.
ONE YEAR WARRANTY
We guarantee each new EuroSurgeTM to be free from defects in material or
workmanship and to perform under normal use and service. This guarantee
shall run for a period of one year from the date of purchase, and obligations
under this guarantee are limited to remedying any defect or replacing any
defective product and shall be effective only if the defective unit is returned
to us within 12 months after purchase. Damage due to abuse, misuse, or
overloading is not covered by this guarantee. We shall not be responsible
for any other loss or damage that may arise through the use by a purchaser
or others of this device, and the purchaser assumes such responsibility and
will hold Hybrinetics, Inc. harmless in respect to all such loss or damage.
Important: This is a factory direct warranty. Do not return defectives to
your retailer. All defectives must be returned to the factory accompanied
by a sales receipt with the original date of purchase. For more informa-
tion please call our toll free number:
(800) 247-6900.
V
OLTAGE
V
ALET TM
EuroSurge TM
220-240 Volt Surge Protector
Portable Surge Protection for World Travelers
Model SP2
Instruction Manual
Read instructions before using this appliance
Voltage Valet Division, Hybrinetics, Inc.
225 Sutton Place, Santa Rosa, CA 95407
©1997 Hybrinetics, Inc.