Cobra Electronics MC600Cx EN - Manual (Page 14)

Nothing Comes Close to a Cobra ® 9
General Operation
When the field is highlighted:
1. Use the R
IGHT
or L
EFT
software buttons at the bottom to highlight the field
you would like to change.
2. Use the UP, DOWN, RIGHT or LEFT CURSOR buttons to step through
the available characters until the desired character is highlighted.
3. Press the ENTER button to confirm; the selected character appears in the
highlighted field on the top line.
4. Repeat this procedure until you complete your entry.
5. Press the S
AVE
software button when the entry is complete.
This keypad is designed to reduce the number of button presses needed naming
points and entering data. It can be disabled and the more conventional method
used. If desired, it is disabled from the General settings of the SYSTEM Page.