Canon FB630U/FB636U - Manual (Page 9)

9
Quick Start Instructions
Those who wish to start scanning immediately should follow the procedures below. If
you require further information at any stage, read the pages referenced at each step.
Installing Plug-in Module CS-U
Follow the instructions described in the Quick Start Guide to
install the software.
Start Plug-in Module CS-U p. 13
1. Connect the scanner to the computer, then start Canon Photo.
2. Select [CanonPI CS-U 3.3.0...] as the image source (this step is
only required the first time the scanner is used with the
program).
3. Select Get From Scanner. Select CanoScan FB630U/FB636U.
Then click Get Pictures Now.
• Plug-in Module CS-U will start and display its control panel.
Start the Preview Scan p. 15
1. Place the materials to be scanned on the scanner.
2. Click the [Preview scan] button (
).
• The entire document glass area will be scanned and displayed in the
preview scan window.
Preview Window
Plug-in Module CS-U automatically calibrates itself the first time the preview or
scan button is clicked. The scanner will run by itself for a few moments without
displaying an image in the window. This does not constitute a breakdown. The
calibration results are stored until the computer power is shut off.
1 1
2
2
3
3
➟
*Plug-inModuleCS-U3.3/1-70 12/1/99, 8:36 AM 9