Welch Allyn Connex with EarlySense Monitoring - Quick Reference Guide User Manual
Welch allyn connex, With earlysense monitoring, Quick reference card
Advertising
Welch Allyn Connex
®
with EarlySense Monitoring
Quick Reference Card
Connect the patient movement cable
1. Align the EarlySense cable connector with one of the EarlySense ports on the
right side of the monitor.
3. When you are ready to monitor a patient, position the bed sensor (sensing unit)
as follows:
• horizontally under the patient’s mattress
• the top surface of the sensing unit facing the mattress
• the sensing unit under the patient’s chest area
• the sensing unit cable extending toward the head of the bed
2. Insert the cable connector until it clicks into place. Also check the stress relief
connector on the cable to ensure that both parts of the cable are tightly connected.
Advertising