Welch Allyn Connex Central Station Quick Reference Card - Quick Reference Guide - Manual (Page 2)

© 2013, Welch Allyn, Inc. All rights reserved. Mat. No. 719883, 80018371 Ver. A 105349
Connect to the central station
1. Touch the Settings tab. The Monitor tab appears.
2. Select Connect to central station.
As the device attempts to connect to the central station, a appears in the
Device Status area. When the device connects to the central station, the
indicator appears.
Note The device must be in the Continuous Monitoring profile to set up a
continuous connection to the central station. When the device is in the
Continuous Monitoring profile, the device automatically connects to the
central station when you navigate to the Patient tab or apply continuous
sensors to the patient.
Disconnect from the central station
1. Touch the Settings tab. The Monitor tab appears.
2. Select Disconnect from central station.
If reasons for disconnecting from the central station have been configured in
Connex CS, a Disconnect dialog appears with a list box of reasons.
3. Select a reason for disconnecting, if applicable, then touch
OK.
The Home tab appears.
Pause continuous monitoring (Standby mode)
1. Touch the Settings tab. The Monitor tab appears.
2. Touch Standby.
A “Standby” dialog appears, indicating that you have paused continuous monitoring.
Controls on this screen provide options to resume or end monitoring. A countdown
timer displays the time remaining before continuous monitoring resumes.
Resume continuous monitoring
Standby time remaining
1. Reconnect patient sensors to the patient as needed.
2. Touch
Resume monitoring.
The Home tab appears and continuous monitoring resumes.
Standby time limit expired
If the standby time limit runs out before you resume monitoring, the device exits
Standby mode, and alarms might occur.
Reconnect patient sensors to the patient and/or device, and acknowledge alarm and
information messages as needed. Continuous monitoring resumes.
End continuous monitoring
1. Touch the Settings tab. The Monitor tab appears.
2. Touch End monitoring.
An “End monitoring” dialog appears with the following options:
• New patient – Clears patient and location context and review data after you
remove patient sensors
• Power down – Clears patient and location context and review data, and powers
down the device
• Cancel – Retains patient data and returns to the Home tab
3. Select the desired option.
a. If you select New patient, follow the onscreen prompts to remove sensors
from your patient.
b. Touch
OK. The Home tab appears.