Welch Allyn Propaq LT v1.60.07 Update Application - Installation Guide - Manual

80019284 B 1
Propaq LT v1.60.07 Update Application – User Instructions
1. Required Equipment

Propaq LT v1.60.07 Update Application CD (410440)

Propaq LT Power Adapter (503-0142-01)

USB/Comm Charging Cradle (008-0873-00/007-0164-00)

USB cable, type A-B (008-0882-00 or equivalent)

PC with one of the following operating systems: XP Service Pack 3, Windows 7 (32/64 bit)
PC admin rights are required to install the Update Application to a PC.
To avoid possible driver conflicts, uninstall any other Welch Allyn utilities or install the Update
Application on a PC that has no other Welch Allyn utilities installed.
Important: If you have a model 802LTAN and have temporarily disabled your wireless (radio)
communications and intend to re-enable the radio at some point, please see Section 4.
Note: After the software update, the Propaq LT configuration settings will be reset to factory defaults.
2. Installation
1. Insert the Propaq LT v1.60.07 Update Application CD into the CD/DVD drive of the installation PC.
Depending on your PC settings, Windows AutoPlay may start the installation or provide the option to
run setup.exe. If AutoPlay doesn’t start, browse the CD and run setup.exe.