Cleveland Range Open Base & Modular Gas Skillet SGL-30-TR - Manual (Page 7)

START UP PROCEDURE
This appliance has been factory tested and adjusted
under ideal conditions but, rough handling, low gas
pressure, altitude or variations in gas characteristics
may require fine adjustment.
All units are equipped with fixed orifices and do not
require primary air adjustment.
LIGHTING INSTRUCTIONS
NOTE: This appliance is equipped with a direct spark
ignition system. Ensure gas and electrical supply to the
appliance, are in the 'ON' position.
1. Turn the main manual gas shut-off valve to the 'ON'
position.
2. Turn power switch to the 'ON' position.
3. Set thermostat to desired temperature.
4. If ignition fails and/or the control system goes into
lockout, set power switch to the 'OFF" position.
5. Wait 5 minutes then repeat steps 1 through 3. If the
problem persists, have a qualified serviceman
check the system.
6. To shutdown system, turn power switch and main
manual gas valve to the 'OFF' position.
OPERATING INSTRUCTIONS
1. Ensure gas and electrical supply to the appliance
are in the 'ON' position.
2. Turn power switch to the 'ON' position. The green
pilot light will indicate power is on. Wait one minute
to allow flame sensor to heat up.
3. TILTING OPTIONS
Note: Before tilting the pan make sure the lid is
open.
PowerTilt
Cleveland skillets are equipped with an electric
power tilt mechanism for raising and lowering the
frypan. To raise frypan, raise the cover and press up
on the tilt switch. To lower frypan, press down on the
tilt switch.
Manual Tilt
Cleveland skillets can also be equipped with the
optional manual tilt mechanism for raising and
lowering the frypan. To raise frypan, raise the cover
and turn the wheel clockwise. To lower frypan, push
in on the lever located behind the wheel.
4. FOR YOUR SAFETY, this skillet is also equipped
with a power interrupter which automatically shuts
off the gas supply to the burners whenever the
skillet is raised more than 1/2" (13mm).
5. Turn power switch to the 'OFF' position when skillet
is not in use.
6. During an electrical power interruption, turn power
switch to the 'Off position. This unit cannot be made
to operate without electrical power or gas supply.
OPERATING SUGGESTIONS
IMPORTANT: Always raise the spring assist cover
before activating the tilt mechanism. Before
commencing to cook, ensure frypan is in the lowered
position by pressing down on the tilt switch.
1. To preheat, set thermostat to desired cooking
temperature. The amber pilot light will cycle on and
off with the thermostat.
2. Allow skillet to preheat for approximately 15-30
minutes.
3. Once preheated, insert product in skillet and adjust
thermostat to required cooking temperature.
4. If desired, once product has cooked, it can be held
prior to serving at a lower temperature setting.
5. When cooking is completed, set thermostat and
power switch to the 'OFF' position.
6. The best time to clean the skillet is immediately after
use, once skillet has cooled down.