Welch Allyn CP100 And CP200 Software Upgrade Instructions - Installation Guide - Manual

1 of 8
4341 State Street Road
Skaneateles Falls, NY 13153-0220
706342, Ver: B
Dear Welch Allyn CP 100/CP 200 Electrocardiograph owner:
Enclosed please find the complimentary software upgrade for your CP 100/CP 200 Electrocardiograph
device. In our continued effort to deliver superior product support, the new software provides enhanced
capabilities that will improve your experience while using the device. Please review this information to make
sure you are familiar with all the latest improvements to your device(s).
Directions for updating the software are included. The entire process takes only a few minutes to complete.
Should you have any questions regarding any of this information, please do not hesitate to contact Welch
Allyn Technical Support (in the US 1-800-535-6663) or your local Welch Allyn Technical Support
representative.
Regards,
Steve Kenan
Sr. Product Manager
Cardiopulmonary Group
Welch Allyn, Inc. 315-685-3619
CP 100 and CP 200 Software Upgrade Instructions
Caution Do not unplug or turn unit off during this process. It will cause
the system to be inoperable.
Note You cannot uninstall updates made to the unit.
Procedure
1. Power ON unit.
2. Insert the SD memory card into the slot on the unit.
3. Press the Menu key.
4. Choose Main Menu > Systems Settings> Device Info > Upgrade
Software
The Upgrade Software screen displays. See Figure 1.
5. Press the “Upgrade” Soft key button.
The upgrade takes approximately 60 seconds to complete.
The unit will reboot.
6. Reset the Date and Time on the unit after it reboots. See the Directions
for Use manual.
Verify Update
1. Choose Main Menu > System Settings > Device Info > About.
2. Compare product version to what was installed.
Upgrade Sof tware
Currently Inst alled On Memory Card
X.X.X X.X.X
Upgrade
Figure 1: “Software Upgrade” Screen Example