Workrite Sierra Pin Crank Assembly Instructions for 3-leg Workcenters User Manual
Page 3
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
3
Sierra Pin Workcenters - Assembly Instructions for 2 and 3-leg Tables
1
Verify that you have all the hardware and tools needed for the assembly
Check your cartons against the list on page 2 to verify that you have all the parts needed.
You will also need the following tools:
#3 tip Phillips screwdriver or drill bit
If you do not have a WorkRite tabletop, you will also need a:
⅛" pilot drill bit
2
or
3-Leg Tables Only: Attach Crossbars to Center Leg Bracket using
¼-20 x ⅝" Button head Machine Screws and
5
/
32
"
Allen Wrench
For 2-Leg table assembly, please
proceed to Step 3.
To avoid stripping the threads, always insert and
make the first few turns of the screw BY HAND
with an Allen wrench, ensuring it is in straight.
D
C
E
E
D
F