Workrite Sonoma Series PREMIUM User Guide - Manual (Page 4)

Description of Sonoma Series™
Premium System:
Each Premium leg assembly is equipped with a motor. Parallel
memory drive is ensured by means of software in the control box
that also takes account of offset loads on the worksurface. Soft
start and stop are also part of this software.
Duty Cycle:
Irrespective of load, the duty cycle of this system is 10%. This
equates to 6 min. per hour or a maximum of 2 minutes of continu-
ous use. This duty cycle must not be exceeded as this will result
in damage to the motor and control box. Exceeding the duty cycle
will result in a dramatic reduction of the life of the system.
Normal Operation:
To run the table up or down, press the UP or DOWN button, and
keep it pressed until the table reaches the desired height. The
display will count up or down while running and after stopping it
will continually show the current height of the table.
Changing display readout between
centimeters and inches:
Keep the “S” button pressed for 3 seconds, the readout will now
change from the current setting.
How to store a memory position:
Run table to the desired height. Press the “S” button and within
2 seconds press memory button 1, 2 or 3. The display will
acknowledge by showing S1, S2 or S3 for 1 second.
To abort a store sequence, press the UP or DOWN button while
the “S” is flashing, or wait the 2 seconds until the display returns
to show the height of the table.