Workrite Sierra Privacy Panel User Manual
Parts by carton, Ab a b
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
#1500128 - Rev B
E
5
/
32
" Allen Wrench
Qty: 1
D
Washers
Qty: 2
C
Set screws
Qty: 2
A
Sierra Tool Bar or Privacy Panel
Qty: 1
B
Stanchion
Qty: 2
Parts by Carton
Assembly Instructions
for Sierra Tool Bar and
Sierra Privacy Panel
Attach Tool Bar or Privacy Panel to Stanchions
Align Tool Bar with holes in Stanchion. Notice that the sections of the Tool Bar are not symmetri-
cal and position the Tool Bar with the short section on the top.
Push Tool Bar into holes in Stanchion. Be sure it is pushed all the way in.
Repeat for the other Stanchion.
1
A
a
b
a
b
B
Verify that you have all the hardware needed for the assembly.
OR
If you have purchased the SwingArm Sierra Tool
Bar mount (SAPAN01), mount it to the Tool Bar
BEFORE attaching Tool Bar to Stanchions.
Note: Shortest
bar on top
Two persons might be required to install longest
versions of Tool Bar/Privacy Panel.