Workrite Willow Dual-Wide Upgrade Instructions - Manual (Page 3)

Workrite Ergonomics 800.959.9675 www.workriteergo.com 3
Attach Monitors
4
Quick Release Option:
Attach the Quick Release Bracket (B) to the VESA mount holes on your monitor. Use the screws
from your monitor if possible. The tab on the bracket should be on the bottom.
For Recessed Mounts:
For monitors with recessed mount where the
Quick Release Bracket will not fit into the
mounting location,10mm Plastic Spacers (F)
have been supplied. Install these between
the monitor and the Quick Release Bracket as
shown with the shortest M4 screws possible.
Attach the Willow Arm to the monitor by sliding
the Quick Release Bracket over the mounting
plate.
Note: Your Quick Release Bracket has
convenient storage on its sides for the 3 /
16
"
Allen Wrench (H) and the ⅛" Allen Wrench (O).
Important Note
It is strongly recommended to use the mounting screws provided by the monitor
manufacturer if possible. If longer screws are needed, use either part (C) 18mm long,
(D) 12mm long, or (E) 8mm long. NOTE: Always use the shortest screws possible to
avoid damage to the monitor.
Direct/Secure Mount Option:
Attach the Willow Arm VESA mount to the
VESA mount holes on your monitor. Use the
screws from your monitor if possible. The
clip on the bracket should be on the bottom.
For Recessed Mounts:
For monitors with recessed area where the
VESA mount will not fit into the mounting
location,10mm Plastic Spacers (F) have been
supplied. Install these between the monitor
and the VESA mount as shown with the
shortest M4 screws possible.
Note: Keep your Quick Release Bracket (B)
for possible future use.
OR
a
b
b
a
a
a
F
Use (F) for
recessed
mounts only
!
Tab on bottom
B
F
Use (F) for
recessed
mounts only
!
O
H