Workrite Poise–Dual - Manual (Page 5)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 5
Workrite Poise–Dual™ Installation Instructions
4
3
Attach Monitor Arms to Monitors
Place monitor carefully on a clean, flat
surface, face down.
Attach the monitor arm to the back of the
monitor with four screws, using a Phillips-
head screwdriver (not included). Use the
mounting screws provided by your moni-
tor manufacturer if available. Otherwise,
use the screws provided that best fits
your monitor.
Use the outer holes for a
100mm mount, or the inner holdes for a
75mm mount.
Repeat for the second monitor.
V
X or Y
Remove the center hole from the base cush-
ion, then attach it to the underside of the base,
aligning the hole in the base with the hole in the
protector. Thread the M8 Thread Rod into the
bottom of the base.
Attach 14” pole to base, securely tighten 4 set
screws (already in place).
Place the base on the work surface, centering it
over a bolting hole from 3/8” to 3” in diameter.
Position the U-Bracket and Small Washer onto
the M8 Thread Rod and secure the bracket by
tightening the Wing Nut.
Proceed to step 4.
Grommet Base Only: Attach Grommet Base to Work Surface
a
b
c
d
a
b
c
d
M
E
G
I
J
H
K
L