Workrite SwingArm - Manual (Page 2)

2 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Assembly Instructions for Workrite Poise and SwingArm Sierra Tool Bar Mount #1500131- Rev C
convex side
face up
2
Attach Mount to Tool Bar
Attach cushion to back of Mounting Bracket.
Loosely attach screws to Mounting Bracket and Mounting Plate.
Slide Mounting Plate into Tool Bar opening. Move Workrite Poise or SwingArm Mount to desired
position on Tool Bar and tighten screws using Allen wrench provided with Workrite Poise or
SwingArm.
a
a
b
B
3
a
Secure Tool Bar and Attach Workrite Poise or SwingArm
Attach Stanchion to side of Tool Bar and tighten to worksurface.
Attach assembled Workrite Poise or SwingArm and monitor to Mount and secure with Allen
wrench. Please refer to the assembly instructions that came with your Workrite Poise or
SwingArm for information on attaching and adjusting your monitor and cables.
Tighten set screw inside Mount using M2.5 Allen wrench from Workrite Poise or SwingArm
package, then attach sticker included in Wall Mount package.
b
a
b
D
b
c
c
C
c
c
if your Tool Bar was already
installed, you must remove
one stanchion before
attaching the mounting plate.