Xpres Subli-Print Epson D88: CorelDRAW 10 onwards instructions - Manual

1
Diagram 1 Diagram 2
Diagram 5
Diagram 4
Diagram 3
Diagram 6 Diagram 7 Diagram 8
Diagram 9 Diagram 10 Diagram 11
Click
Advanced
Name it
Subli-print
Click 'Save' then click
OK until all open boxes
are closed.
Installing & Setting up the Epson D88 printer
Insert the Epson Stylus D88 software CD-ROM into your CD-ROM drive. The CD will auto run. Select 'Custom
Install' from the menu, as in diagram 1 below. When Diagram 2 appears click 'Printer Driver'. It will display diagram
3, click OK and it will copy files to your computer. Make sure the USB cable is connected to the PC and printer, then
turn on the printer as instructed in diagram 4. After the utility has found your printer it will confirm this as in diagram 5.
The Epson D88 has now been successfully installed. Click OK.
Now follow the Epson D88 driver setup below.
Browse to the Printers and Faxes folder. Right click on the Epson D88 printer and click on 'Properties'. Click on
'Printing preferences as in diagram 6, then follow the diagrams below.
Click
Save Setting
Click
Mirror Image
1 1
2
2
1
2
3
4
1
2
3
4 . Epson Matte
. Photo
. ICM
. Off (
No Color Adjustment )
After installation
The Epson Status Monitor
needs disabling before
use. Follow the below
steps.
1. Go to the printers and
faxes folder.
2. Right click on the D88
and select properties.
3. Click printing
preferences.
4. Click the Maintenance
tab.
5. Click on the 'Speed &
Progress' button.
6. Un-tick 'Show Progress
Meter'.
7. Un-tick 'Disable EPSON
status monitor 3'.
8. Click OK three times
to close the driver boxes
down.