Changhong Electric LT2618 - Manual (Page 5)

18 Series LCD TV
PAGE 3
produce heat.
22. Panel protection---The LCD panel used in this product is made of
glass.
Therefore, it can break when the product is dropped or impacted upon
by other objects. Be careful not to be injured by broken glass pieces in
case the LCD panel breaks.
23. Pixel defect---The LCD panel is a very high technology product, giving you finely detailed pictures.
Occasionally, a few non-active pixels may appear on the screen as a fixed point of blue, green or red.
Please note that this does not affect the performance of your product.
2jk424hukjiokmImportant Safety Instructions
● Use the remote control by pointing it towards the remote sensor window of the set. Objects between the
remote control and sensor window may prevent proper operation. Cautions regarding use of remote control
Note: the illustration is for your reference only, the remote sensor may
locate differently with different model.
Cautions regarding use of remote control
● Do not expose the remote control to shock. In addition, do not expose the remote
control to liquids, and do not place in an area with high humidity.
● Do not install or place the remote control under direct sunlight. The heat may cause
deformation of the unit.
● The remote control may not work properly if the remote sensor window of the main unit is under
direct sunlight or strong lighting. In such a case, change the angle of the lighting or LCD TV set,
or operate the remote control closer to the remote sensor window.
If the remote control fails to operate the LCDTV functions, replace the batteries in the remote control.
1 Open the battery cover.
2 Insert two size-AAA batteries. 3 Replace the cover and slide in
reverse until the lock snaps.
● Slide the cover while pressing
down.
● Place the batteries with their
terminals corresponding to
the (+) and (-) indications in
the battery compartment.
Precaution on battery use
Improper use of batteries can result in a leakage of chemicals and/or explosion. Be sure to follow the
instructions below.
● Place batteries with their terminals corresponding to the (+) and (–) indications.
Using the Remote Control
Batteries for Remote Control