Putting it away, A warning, When you’re done – Bissell 1725 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

When you’re done

TIP: Before turning off Little Green, vacuum up clean water

to thoroughly rinse the Vacuum Hose. Ilien, lift the tool
and point upwards. This allows any water still in the Hose
to flow into the Collection Tank.

1. Him Power Switch to OFF position,

2. Unplug Power Cord from outlet. Wrap the cord around the

Onboard Cord Storage at the base of Little Green.

3. Remove and rinse Solution Tank, then repl^.

NOTE: If a significant amount of Little Green formula/water remains,
you may leave it in the Solution Tank for your next cleaning task.

4. Remove Collection Tank, fill with clean water, rinse

thoroughly and discard.

5. Replace Collection Tank.

6. Disconnect the tool from Grip/Trigger unit by pushing down

on button lock and pulling straight off.

(Do NOT twist tools to remove them).

7. Once removed from the Vacuum/Flex Hose, the tools can

be cleaned;

a. 4”, 6”, or Crevice tool - Rinse under clean

running water.

b. TUrboBrush tool - Switch must be in “SUCTION”

position. Rinse under clean running water.

8. Check Spray Nozzle for accumulated dirt or debris.

If necessary, clean witl: soft bristle brush.

9. See “Putting It Away” on page 7.

A WARNING:

Keep face aw^ from spray.
Failure to do so may result
in personal injury.

Putting it away

1. After deep cleaning of carpet or upholstery, follow

instructions in “When You’re Done," above.

2. Wipe all surfaces with a soft cloth.

3. Wrap Power Cord around On Board Cord Storage

at the bottom of Little Green.

4. Wrap Vacuum Flex Hose around Onboard

Hose Storage and secure Grip/Trigger.

5. Store Cleaner in a protected, dry area, at

room temperamre (40° to 110°F).

NOTE: For Little Green HirboBrush® Models,

on-board storage for the HirboBmsh® Tool

has been provided on the back of die unit.

Attach the TbrboBrush® to the unit by

pressing tool onto holder firmly until

button snaps into hole.

Cord Storage

1720-1
1720-2

Little Green

TttrboBrush

1720-5
1720-6

Little Green

liirboBrush

Built-in

Heater

1725

1725-1

Little Green

ProHeat

liirboBrush

Advertising