Motorola AW 7390 - Manual (Page 2)

WARNING Operating instructions
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
The Model and Serial Numberwill be
found on the type plate on the base
of the set. Please record the Model
and Serial Number in the space
provided below.
MODEL
NUMBER:
SUPPLY
Battery supply
• Open the battery compartment (fig. 2) and insert as
indicated six D-cells.
• Remove the batteries if exhausted or if they will not
be used again for a long period.
The battery supply is switched off when the set is
connected to the power. To change over to battery
supply, pull out the plug from the MAINS jack.
120 V AC power supply
• This set is suited for 120 V, 60 Hz AC.
• Connect the power cord to the MAINS jack and the
wall outlet. The power supply is now switched on.
• To disconnect the set from the power completely,
withdraw the power plug from the wall outlet.
SERIAL
NUMBER:
This set complies with the FCC-RuIes, Part 15
RADIO RECEPTION
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN I / •
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL
A This symbol Is intended to alert the user of the
presence of uninsulated ’dangerous voltage' within
the product's enclosure, that may be of sufficient
magnitude to constitute a risk of electric shock to
persons.
This symbol is intended to alert the user of the
presence of important operating and maintenance
(servicing) instructions in the literature accompa­
nying the appliance.
• Set the FUNCTION selector to RADIO ON.
• Adjust the sound with the controls VOLUME and
GRAPHIC EQUAUZER.
You may connect stereo headphones vrith 3.5 mm plug
to jack PHONES. The speakers are then muted.
• Select the wave band using BAND selector.
• Tune to a radio station using TUNING knob.
- For FM, pull out the telescopic antenna. To improve
FM-reception, incline and turn the antenna. Reduce
its length if the FM-signal is too strong (very close to
a transmitter).
- For AM, the set is provided with a built-in antenna, so
there is no need to use the telescopic antenna. The
antenna can be directed by turning the whole set.
• When the FM STEREO indicator lights up, you are
receiving a FM-stereo transmitter. A disturbing noise,
due to a weak FM-stereo signal, can be suppressed by
setting the BAND selector to FM MONO. The FM
STEREO indicator will then go out and you will hear
(and record) the FM program in mono.
• The set is switched off if FUNCTION selector is in
position TAPE or RADIO OFF and the recorder buttons
are released.
CASSETTE RECORDER______________
Copyright: Recording is permissible insofar as copy­
right or other rights of third parties are not infringed.
Fast winding : Press K< or ►►!. To stop, press STOP ■.
Safeguarding against erasure: Keep the cassette
side to be safeguarded in front of you (fig. 4) and break
out the left tab. Now. recording on this side is no longer
possible.