Bissell 1337 - Manual (Page 2)

OPERATING
INSTRUCTIONS
Assembie handle.
@ Vacuum carpet before shampooing. Test for
colour fastness on small inconspicuous
area. Furniture remaining on carpet should
have feet protected with foil wrapping.
^ Fill tank with 1 part BISSELL Foam Carpet
Shampoo to 10 parts tepid water, DO NOT
USE HOT WATER. Tank capacity is 1.8 litres.
Plug in appliance to suitable wall socket.
See separate order form for Bisseii
Shampoo,
To commence shampooing press ON/OFF
foot operated switch at rear of appliance
housing and also release shampoo supply
by using push button control on handle.
Ill When foam appears move slowly and evenly
over the carpet. Always work in the direction
of the pile, slightly overlapping each area
cleaned to avoid leaving any carpet
untreated.
@ DO NOT OVERWET THE CARPET - Once a
small amount of foam has been generated,
release the push button on the handle and
allow the power brush to massage the
cleaning foam into the carpet pile. Then
repeat the process on the next area of
carpet. After shampooing, press foot
operated switch again to stop appliance.
ti Leave carpet to dry completely. Ideally the
carpet should be aiiowed to dry overnight.
When dry, thoroughly vacuum.
lil Your appliance must be cieaned after use.
Empty tank of all shampoo solution and half
fill with clean water. Hold shampooer over
sink, press trigger and thoroughly flush
through, Wash brush and roller assembly
with dean water. To avoid blocking shampoo
distributor it is very important that appliance
is completely emptied before storage.