Figure 1-16 – Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
F i g u r e 1 - 1 6 . R o t a t i n g t h e F r o n t M o u n t i n g B r a c k e t f o r F l u s h - M o u n t
I n s t a l l a t i o n
9
10
the other slide assembly.
Repeat steps C and 5 to eonfigure the other slide assembly.
Holding the left slide assembly into position in the two-post raek at the loeation you
marked, adjust the extended baek braeket tightly against the vertieal two-post raek and
seeure it with three 12-24 x 0.5-ineh pan-head Phillips serews (see Figure 1-17).
Seeure the front braeket on the slide assembly to the two-post rail with two
12-24 x 0.5- ineh pan-head Phillips serews (see Figure 1-17).
Perform steps 7 and 8 to install the right slide assembly in the raek.
Use an 11/32-ineh wreneh or nut driver to fully tighten the nuts on the mounting
braekets on both slide assemblies that you tightened with your fingers.
R a c k I n s t a l l a t i o n G u i d e
|
1-25