Compex Technologies COMPEX WIRELESS-G WLP54G - Manual (Page 2)

3. Utility and Driver Installation
1. Power on your PC and your system will detect new hardware
automatically. Click Cancel to terminate the driver installation.
2. Insert the Product CD into your computer CD-ROM drive. The
CD will auto-run, displaying the Compex page. Then go to
UTILITIES to select the setup.exe
3. The system will then run the RaLink2_RT2500 setup.exe
automatically. Click Next> to proceed.
4. Follow the instructions stated on the screen. The system will
prompt you if you need to select your location country. For
example, if you are in Singapore, just select Singapore. Click OK
to proceed.
5. Click Finish to complete the utility installation. At the same time,
your system has installed the driver to your computer.
However, you will notice that the RALINK Wireless Utility
screen appears automatically, together with the RALINK
Wireless Network Card Setup. Before you can configure the
Utility program, first exit the latter by clicking Finish.
If you wish to exit the utility program, simply go to the taskbar
and place your cursor on the icon (as circled in red). Then click
on the right button of your mouse to select Exit from the main
menu.
To check if the driver has been successfully installed to your system,
6. Proceed to your desktop, right click on My Computer and select
Properties.
7. Select Hardware tab and click on Device Manager.
8. Ralink RT2500 Wireless LAN Card will appear in the Network
Adapters section. This indicates that the drivers for Compex
iWavePort WLP54G has been successfully installed to your
system.