Operating instructions, Master/slave & stand-alone mode, Daisy chain connection – Chauvet LED-RAIN36 User Manual
Page 7: Perating, Nstructions
LED-RAIN36 User Manual
7
2006-07-14/15:25
1
2
3
4
5
6
7
8
9
0
1
ON
FUSE
POWER
IN AC
POWER
OUT AC
IN
OUT
DMX512
COLORsplash Jr.
TM
1
2
3
4
5
6
7
8
9
0
1
ON
FUSE
POWER
IN AC
POWER
OUT AC
IN
OUT
DMX512
COLORsplash Jr.
TM
1
2
3
4
5
6
7
8
9
10
ON
Master Setting
Slave Setting
1
2
3
4
5
6
7
8
9
10
ON
1
2
3
4
5
6
7
8
9
0
1
ON
FUSE
POWER
IN AC
POWER
OUT AC
IN
OUT
DMX512
COLORsplash Jr.
TM
1
2
3
4
5
6
7
8
9
0
1
ON
FUSE
POWER
IN AC
POWER
OUT AC
IN
OUT
DMX512
COLORsplash Jr.
TM
1
2
3
4
5
6
7
8
9
0
1
ON
FUSE
POWER
IN AC
POWER
OUT AC
IN
OUT
DMX512
COLORsplash Jr.
TM
1
2
3
4
5
6
7
8
9
0
1
ON
FUSE
POWER
IN AC
POWER
OUT AC
IN
OUT
DMX512
COLORsplash Jr.
TM
Optional DMX Controller
AC Line
Use 3-pin XLR DMX cable
Use AC linking cable for convenience. As many as 50 par cans
can be powered from one AC daisy chain connection.
Continue
Continue
O
PERATING
I
NSTRUCTIONS
The LED-RAIN36 is a DMX-512 controllable, pinspot made up of highly efficient and super bright
white LEDs. The LED-RAIN36 can operate in Stand-Alone, Master/Slave and via DMX-512 control
utilizing 2 channels.
Master/Slave & Stand-Alone Mode
The Master/Slave mode will allow you to link up to as many units you want in a daisy chain fashion. In
this mode, the first unit in the daisy chain will automatically command all other units following.
1. Connect all LED-RAIN36 units in a daisy
chain fashion as described in the section
following.
2. Master Unit: Set dipswitch #10 to OFF.
3. Slaves: Set dipswitch # 10 to the ON position
and all others to the OFF position.
4. You can also run the fixtures in an automatic
stand-alone mode by simply setting all
fixtures to run as master units.
D a i s y C h a i n C o n n e c t i o n
1. Connect the (male) 3 pin connector side of
the DMX cable to the output (female) 3 pin connector of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,
proceed to connect from the output as stated above to the input of the following fixture and so on.