Vermont Casting VCS501 - Manual (Page 3)

3 30005436
VCS501 Series Assembly
CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly, lifting or mov-
ing the grill is recommended.
Step 2a: Install the Casters
This step requires  people.
Parts Required:
(4) Casters ( with brake, rear;  without brake, front)
(1) Block (not included)
(16) 1/4-0 Flange Nut (30005406)
Figure 1
NOTE: Casters (wheels) may differ from those shown in the illustration depend-
ing on the model you purchased.
Select a side to begin installing the casters. Place a block of wood, thick tele-
phone book or anything else available - approximately 6 inches thick - under the
side to support the weight of the barbecue. Insert the four (4) bolts attached on
the casters into their respective holes located on the bottom, near the front. If you
have any difficulty snapping them into place, try rotating the casters in a circular
motion.
As one person holds the front caster in place, the other opens the front
door and installs four (4) flange nuts. Tighten the flange nuts on
the front caster. Repeat this process with the rear caster.
When both casters are in place on one side, repeat the
same procedure on the opposite side.
B346
install casters
Figure 1
Rear Caster
w/Brake
Blocking
Front Caster
without Brake
B346