Cooper Lighting ADY071447 - Manual

40
1. To secure yoke to outdoor surface, the fixture head must be
removed. First, remove both #10-32 x 5/8 end screws.
2. Remove one #6-32 x 1/4 screw to remove yoke end cap and
fixture head. Place both fixture head and yoke end cap in a
safe place.
3. With fixture head and yoke end cap safely stored, secure
yoke to outdoor surface using four(4) appropriate 1/4"
fasteners (by others).
Mounting yoke to outdoor surface
#10-32 x 5/8
End screw (x2)
Yoke end cap
Yoke end cap
1/4 Fasteners
(by others) (x4)
#6-32 x 1/4
screw(x2)
Aiming the fixture
1. To aim fixture, loosen both #10-32 x.625 end screws. When
the PointGrab
TM
system indicators are lined up, the slope
of the lens face is 40-degrees. Each subsequent notch is
an additional 10-degrees.
2. When the fixture head is adjusted to the desired angle, re-
tighten end screws to secure the position.
Fixture head
indicator
Yoke arm indicator
#10-32 x 5/8
end screws
#6-32 x 5/8
Socket cap screw
(x3)
#6-32 x 1/2
Socket cap screw
(x2)
1/2" Compression
fitting
1. To seal fixture head, after installing lamp, all screws and
latches must be secured on door face. Holes above latches
receive the #6-32 x 1/2 socket cap screws. The center hole(s)
receive the longer #6-32 x 5/8 socket cap screw.
2. Slide 1/2" compression fitting down fixture head wire and
splice wit power feed, ensuring all connections are properly
matched. Seal 1/2" compression fitting to outdoor surface and
ensure a watertight seal.
#10-32 x1
End screw
Fixture head
#6-32 x 5/8
Socket cap screw
(x3)
#6-32 x 1/2
Socket cap screw
(x2)
Yoke
Outdoor J-box
(by others)
1/2" Compression
fitting
Yoke end cap
1/4" Fasteners
(by others)
#6-32 x 1/4
Screw (x2)
Exploded view and part call-out
Wiring and sealing outdoor fixture
Warning : Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician. Do not
mount fixtures vertically.
Installation Instructions
Vault C-Scroll Roundel
These installation instructions are valid with the above Ametrix styles.
1
3 2
Sheet 1 of 2
Large, OUTDOOR
YR (16.5")
(Yoke mount, Remote ballast)
Visor and Non-Visor
ADY071447 Rev A (ECN070295)