Axial Racing AX90031 - Manual (Page 5)

Getting-Started Checklist
Range-Checking Your Radio System
The following checklist is a guide for getting your vehicle running for the first time.
Read ‘Cautions’ in Manual. (Page 2)
Familiarize yourself with vehicle and its components.
Even though the vehicle is new check driveshaft setscrews and other screws to make sure they are tight from the factory.
Charge battery pack. (Page 4)
Install 4X AA batteries into Transmitter. (Page 7)
If you are using NiMH or NiCd batteries turn OFF Lipo cut-off on the ESC. (Page 6 'Notes')
Install battery pack in vehicle. (Page 4)
Turn on transmitter FIRST then ESC. (Page 4)
Check to make sure steering and throttle operation work correctly. (Page 7)
Range check radio system. (Below)
Drive vehicle, challenge yourself and have fun!
Maintain vehicle. (Below)
The radio system should be checked before operating the vehicle to ensure it’s operating properly and has adequate range.
1. Turn on the transmitter first and then the vehicle.
2. Have a friend hold the vehicle while keeping hands and loose clothing away from moving parts.
3. Walk away until you are at the farthest distance you plan to operate the vehicle.
4. Steer the vehicle back and forth and throttle both forward and reverse making sure there is no erratic behavior.
5. If any erratic behavior is exhibited do not operate the vehicle, call customer service for further assistance.
Maintaining Your Vehicle
Just like a full size car or truck your RC vehicle must undergo periodic maintenance in order to ensure peak running performance. Preventative
maintenance will also help avoid needless breakages which could result in costly repairs. Below are some suggestions to properly maintain
your vehicle.
• Replace any noticeable bent or broken parts.
• Keep the chassis free of dirt and debris.
• Check for loose screws on chassis especially the knuckle, c-hub, and axle lockout screws.
• Check for wear on the ball joints in the steering and suspension links, replace if necessary.
• Check driveshaft set screws and re-thread lock if necessary.
• Check wheel nuts making sure they’re snug.
• Check tires making sure the beads are still firmly bonded to the entire circumference of the rim.
• Replace transmitter AA’s if the green light is blinking.
• Inspect the spur and pinion gears for damage.
• Check slipper clutch, if applicable, for proper operation. (See page 25 Step 23 for Setup Instruction)
• Check driveline for smooth bind-free operation.
• Check for any loose connections or frayed wiring.
• Check steering operation for any binds.
• Inspect shock absorbers for smooth dampened operation.
• Check receiver antenna to confirm it’s not damaged.
5