Axial Racing AX90033 - Manual (Page 9)

9
ESC Instructions
Connect the ESC wires to the motor.
Continue applying full throttle
Black
Black
White
Red
Orange Black
Red
ESC blinks green and
emits De Le De Le De Le tone. ESC blinks red and
emits De Le De Le De Le tone. ESC shows no LED's and
emits De Le De Le De Le tone.
Apply full brake Set to neutral point
Green LED
De Le De Le...
De Le ...
Apply and hold full throttle on the transmitter.
Turn on the ESC and it will emit a series of tones,
De Le De Le De Le, the red and green LED will flash
then only the green LED will remain blinking.
The ESC will emit a final
short series of tones,
De Le De Le, confirming it
has been calibrated.
Plug the ESC wire into the
throttle channel on the receiver. Before plugging the battery into the ESC.
make sure your transmitter is on
and the throttle trim is set at zero,
and the ESC switch in the OFF position.
Apply throttle to make sure the motor
is going the direction you wanted. To reverse the direction of the motor,
switch the wires going to the motor.
Or reverse the transmitter throttle reverse switch. Do NOT reverse the battery wire connections!
Reversing the battery polarity will permanently
damage the ESC.
Red LED
De Le De Le ... De Le De Le ...
Green LED
Red LED
No LED
ON 1
2
OFF
TH-TRIM
1
2
3
If you're using NiMH or NiCd batteries turn " OFF " LiPo Cut- Off by visiting
the following link for Manually Programming the AE- 2 ESC : http: //www. axialracing. com/instructions .
ST-TRIM TH-TRIM ST-D/R
BIND