B&C Technologies A-Computer Programming (HE Series) - Manual (Page 12)

Programming
Setup Mode
The setup options are programmable options
that are in operation during all wash cycles.
The options are:
>
Temperature displayed in degrees
Celsius or Fahrenheit.
>
Spray Rinse and Supply 4 enabled
>
Auxiliary heat and Spray Rinse enabled
> Auxiliary heat and Supply 4 enabled
Take note that these options can only be
changed while in Setup mode.
Temperature Display
This setup option affects the display and
programming of all temperatures.
selects CEL
programming/display in degrees Celsius, while
FAR selects degrees Fahrenheit. The Up and
Down keys toggle between the two settings.
The Start key accepts the selection and moves
you to the next setup option.
Spray Rinse, Supply 4, and Auxiliary
Heating
This setup option allows you to select among
the following options:
>
Spray Rinse and Supply 4 enabled
>
Auxiliary heat and Spray Rinse enabled
>
Auxiliary heat and Supply 4 enabled
To enable Spray Rinse and Supply 4, use the
up and down key to see
. When this SRIN
option is selected, Spray Rinse and Supply 4
are enabled, as well as Supply 7 (Supply 3 and
Supply 4 combined). This is the default setting.
When this option is selected, no further
programming in Setup is possible. Press the
Stop key to exit Setup.
To enable Spray Rinse and Auxiliary Heating,
use the up or down key to see
instead of HEAT
SRIN, as above. Now press the Start key
(enter). Now use the up or down key to see
SRIN. Press the start key (enter). No
further Setup programming is possible. Press
the Stop key to exit Setup.
To enable Auxiliary Heat and Supply 4, press
the Up or Down key to see
. Press the HEAT
start key (enter). Now press the Up or Down
key to see
. Press the Start key to select, SUP4
and press the Stop key to save and exit Setup
mode. This is the default mode for machines
without Spray Rinse.
Advance Enable
This option allows you to enable or disable the
advance function. When enabled, a cycle in
operation can be advanced by pressing the Up
and Down keys simultaneously.
enables ADN1
the advance function. disables the ADN0
function.
Cycle Count
To display the current cycle count, press the
Start key after entering Program mode (the
display will show the current temperature in the
wash cylinder). The display will show a 2 digit
number indicating how many cycles have been
completed (cycles interrupted are not counted).
Press the Start key again to return to program
mode without resetting the count. Press the Up
or Down key to reset the count to zero and
return to program mode.
Cycle Programming
To edit an existing cycle, or create a new one,
press the Up key while the wash cylinder
temperature is displayed. The display will
change to show
. Press the up or down CY01
key until the cycle number you wish to
change/create is displayed. Now press the Start
key to begin editing your cycle. Please note
that the test cycle cannot be displayed or
altered.
Segment Display Segment Display
Prewash PRE Fill 3 FIL3
Wash UASH Fill 4 FIL4
Fill 1 FIL1 Fill 5 FIL5
Fill 2 FIL2 Fill 6 FIL6
Cycle Segments
11